It is not intended for anyone to walk or step on. KEY SWITCH LOCATION-all controls for the cover system must be located where the pool is completely visible during cover operation.ĪLUMINUM LID - the aluminum lid on below-deck systems is a long-lasting cosmetic cover for the housing. Never allow anyone to swim under the cover. A partially covered pool can pose a safety hazard. PARTIALLY COVERED POOLS-always completely cover or uncover the pool. The pump is covered under the pump manufacturer’s warrant. One inch of water on a cover can weigh thousands of pounds. Do not operate the cover with water on it. You must follow all pump manufacturer’s instructions regarding its use and maintenance.Īfter the pump has removed all water from one location on the cover, it may be necessary to move the pump to other locations to remove all accumulated water. The pump should be upright on its base in the middle of the cover and plugged into a GFI protected outlet whenever the cover is over the pool. Every cover system comes with a pump that automatically senses water and removes it, provided the pump is operable, properly placed, and maintained according to the pump manufacturer’s instructions. Any accumulation of water on the surface of the cover must be removed immediately. If a salesman or installer gives information that contradicts this manual, you should disregard their instruction on that topic.Ī cover with water on it poses the same safety hazard as an open pool. This information is intended to instruct cover system owners in the proper operation and maintenance of their cover system. LEADING EDGE-the leading edge which pulls the cover out over the pool should not drag on any portion of the deck or coping as it travels back and forth across the pool. Your cover is a very large piece of fabric that rolls around a 6” tube, and controlling exactly how it rolls up is a matter of pool configuration, deck surface adhesion, and environmental conditions.ĭECK SURFACE - any rough or sharp edges on the deck that the cover travels over should be rasped or ground smooth. Some variance is allowed because of the diverse applications in which covers are used. When a cover gets tight between cover guides, it operates under significant stress, may be unsafe, and should be replaced.ĬOVER ROLL-UP - covers should retract and extend within 2-3 inches of being square to the mechanism at both ends of the pool. This shrinkage will amount to several inches over the life of the fabric. All covers shrink slowly over a period of years when exposed to the elements and pool chemicals. SLACK - with the guides properly installed you will have the correct amount of slack in your cover to ensure reliable operation for many years. A few standard things that are easily checked which indicate if the system has been properly installed are listed below. Keep the pump on the cover and set up for proper use whenever the cover is over the pool. Check cover frequently for signs of premature deterioration or weakness.Ī question that is often asked is how one can tell if an installation is done correctly. WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times.Īll field-installed metal components such as rails, ladders, drains, or other similar hardware within 3m of the unit shall be bonded to the equipment grounding bus with copper conductors not smaller than No. IMPORTANT SAFETY INSTRUCTIONS: READ AND FOLLOW ALL INSTRUCTIONS.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |